Suction Screen Replacement

Suction Screen Replacement

Tools Required

* J 42220 Universal Leak Detection Lamp
* J 44551 Suction Screen Kit

Removal Procedure




1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging.
2. Remove the A/C compressor hose assembly bolt.
3. Separate the A/C compressor hose assembly from the A/C compressor.

Important: The suction screens are available in 3 different sizes.

4. Select the proper size removal tool (1) from the J 44551.
5. Remove the suction screen using the J 44551-31.

* Thread the forcing screw into the suction screen.
* Tighten the nut on the forcing screw to remove the suction screen.

Installation Procedure




1. Insert the J 44551-6 (1) into the suction hose to select the correct size suction screen.




2. Insert the suction screen into the suction hose.
3. Install the J 44551-3 (1) to the J 44551-5.




4. Install the J 44551-5 (3) over the end of the suction hose and the suction screen (2).

Important: Correct placement of the J 44551-5 is critical.

5. Tighten the forcing screw of the J 44551-5.
The suction screen is fully installed when the screen is flush with the end of the suction hose.
6. Remove the J 44551-5 from the suction hose.
7. Replace the seal washers.
8. Install the A/C compressor hose assembly to the A/C compressor.

Notice: Refer to Fastener Notice.

9. Install the A/C compressor hose assembly bolt.

Tighten the bolt to 20 N.m (15 lb ft).

10. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
11. Leak test the fittings of the component using the J 42220.