Fuel Injector Sight Shield Replacement

Fuel Injector Sight Shield Replacement

Removal Procedure




1. Remove the oil fill cap (1).
2. Grasp the cover by the upper left and the lower right corners and lift up, disengaging the cover grommets from the ball studs.




3. If necessary, lift upward on front of cover, then reach under center of cover disengaging the cover grommet for the ball stud.

Installation Procedure




1. If necessary, place the cover into position over the ball stud. Press down near the center of the cover, engaging the cover to the ball stud.




2. Place the cover into position over the ball studs. Press down near the upper left and the lower right corners, engaging the cover to the ball studs.
3. Install the oil fill cap (1).