Cylinder Head Assembly

Cylinder head
^ Measure the clearance between the straight-edge and the cylinder head deck face using a feeler gage at 4 points along the straight-edge.
^ If the warpage is less than 0.05 mm (0.002 in), the cylinder head deck surface does not require resurfacing.
^ If the warpage is between 0.05-0.20 mm (0.002-0.008 in) or any imperfections or scratches that could inhibit proper cylinder head gasket sealing are present, the cylinder head deck surface requires resurfacing.
^ If resurfacing is required the maximum amount that can be removed is 0.25 mm (0.010 in).
^ If the cylinder head deck surface requires more than 0.25 mm (0.010 in) material removal the head must be replaced.





Camshaft Cap Bolt 10 N.m 89 lb in





Cylinder Head Bolt - M8

First Pass 15 N.m 10 lb ft
Final Pass 60 Degrees





Cylinder Head Bolt - M11

Important: DO NOT reuse the old M11 cylinder head bolts.

Install new M11 cylinder head bolts.

First Pass 45 N.m 33 lb ft
Final Pass 120 degrees

Camshaft Position Actuator
Camshaft Bolt 58 N.m 43 lb ft

Exhaust Manifold
Bolt 20 N.m 15 lb ft
Heat Shield Bolt 10 N.m 89 lb in

Intake Manifold
Upper-to-Cylinder Head Bolt - Long 23 N.m 17 lb ft
Upper-to-Cylinder Head Bolt - Short 23 N.m 17 lb ft
Upper-to-Lower Intake Manifold Bolt 23 N.m 17 lb ft