Steering Column Tilt Head Replacement

Steering Column Tilt Head Replacement

Tools Required

J 21854-01 Pivot Pin Remover

Removal Procedure





Caution: Restraint System Service Precautions

1. Disable the SIR module.
Remove the turn signal switch housing.
2. Remove the tilt spring.
3. Remove the pivot pins (1) using J 21854-01.




4. Pull the tilt arm in order to disengage the steering wheel lock shoes from the dowel pins (2) in the steering column support assembly.




5. Remove the steering column tilt head assembly (1).

Installation Procedure




1. Install the steering column tilt head assembly (1).




2. Using the tilt lever position, lock the shoes to the dowel pins (2).
3. Rotate the tilt head assembly (1) in order to align the holes for the pivot pins.




4. Install the 2 pivot pins by performing the following steps:

1. Lubricate the pivot pins (1) with, GM P/N 12346293 (Canadian P/N 992723).
2. Press the pivot pins (1) until the pins are firmly seated.
3. Stake the pivot pins at three new locations (1).

5. Install the tilt spring.
6. Install the turn signal switch housing.
7. Enable the SIR module.