Rear Side Door Stationary Window Replacement

REAR SIDE DOOR STATIONARY WINDOW REPLACEMENT

REMOVAL PROCEDURE





1. NOTE: Refer to Paint Damage Notice.

Apply masking tape to the door frame applique.
2. Remove the rear door trim panel.
3. Remove the rear door water deflector.
4. Remove the rear door inner energy absorber pad.
5. Lower the window to the full down position.
6. Remove the stationary window (1) weatherstrip by grasping the center and pulling downward to release it from the retainer.
7. Remove the stationary window bolt (2).
8. Pull the stationary window away from the door.Some back and forth movement may be needed.
9. Remove the stationary window from the door.

INSTALLATION PROCEDURE




1. Install the stationary window (1) it the door.Some back and forth movement may be needed to set the stationary window into the door.

2. NOTE: Refer to Fastener Notice.

Install the stationary window bolt (2)

Tighten the bolt to 10 N.m (89 lb in).
3. Install the window outer belt sealing strip.
4. Remove the masking tape.
5. Inspect the window for proper operation.
6. Install the rear door inner energy absorber pad.
7. Install the rear door water deflector.
8. Install the rear door trim panel.