Coaxial Cable Replacement - Global Positioning System (GPS) (Body Cable)

Coaxial Cable Replacement - Global Positioning System (GPS) (Body Cable)

Removal Procedure




1. Remove the rear seat cushion.
2. Remove the rear seat back.
3. Remove the sail panels.
4. Remove the rear quarter lower panels.
5. Remove the rear upper quarter trim panels.
6. Remove the rear window shelf trim panel.
7. Disconnect the navigation antenna coaxial cable from the navigation antenna.
8. Remove the left front carpet retainer.
9. Remove the lower center pillar trim panel.
10. Adjust the carpet for access to the antenna cable and body harness as required. Refer to Front Floor Panel Carpet Replacement.
11. Remove the left instrument panel (I/P) compartment access hole cover.
12. Disconnect the antenna cable from the antenna extension cable.
13. Cut off the visible ends of the antenna cable from the wiring harness in the following locations:

* The kick panel area
* The rear shelf area

Installation Procedure




1. Install the antenna cable to the vehicle. Use electrical tape in order to secure the antenna cable to the top of the wiring harness. Secure the cable to the harness at least every 150 mm (6 in).
2. Connect the antenna cable to the antenna extension cable.
3. Install the left I/P compartment access hole cover.
4. Install the carpet.
5. Install the lower center pillar trim panel.
6. Install the left front carpet retainer.
7. Connect the navigation antenna coaxial cable to the navigation antenna.
8. Install the rear window shelf trim panel.
9. Install the rear upper quarter trim panels.
10. Install the rear quarter lower panels.
11. Install the sail panels.
12. Install the rear seat back.
13. Install the rear seat cushion.