Radio Replacement

Radio Replacement

Removal Procedure

Important: Perform the radio set up procedure for new radios. Refer to Radio Setup. Programming and Relearning

1. Remove the instrument panel (I/P) accessory trim plate.
2. Remove the I/P center compartment.
3. Remove the HVAC control assembly.
4. Remove the radio screws.
5. Pull the radio toward you.




6. Disconnect the I/P wiring harness connectors and the antenna cable connector from the radio.
7. Remove the radio.

Installation Procedure




1. Position the radio to the I/P.
2. Connect the I/P wiring harness connectors and the antenna cable connector to the radio.

Important: If the radio locator is difficult to align to the I/P locator opening, pull the radio toward you and reposition the antenna cable.

3. Install the radio to the I/P.
Align the radio locator to the hole in the I/P while pressing the radio into position.

Notice: Refer to Fastener Notice.

4. Install the radio screws.

Tighten the screws to 2 N.m (18 lb in).

5. Install the HVAC control assembly.
6. Install the I/P center compartment.
7. Install the I/P accessory trim plate.
8. Perform the radio set up procedure for new radios. Refer to Radio Setup. Programming and Relearning