79. Cylinder Head Installation - Right Side

Cylinder Head Installation - Right Side

Tools Required

J 45059 Angle Meter




1. Install the cylinder head gasket. Ensure the arrows point towards the front of the engine. The right cylinder head gasket has the letter R stamped next to the arrow.

Notice: Refer to Special Fastener Notice in Service Precautions.

2. Install the cylinder head.





Notice: Refer to Fastener Notice in Service Precautions.

3. Install new cylinder head bolts.

Tighten the cylinder head bolts to 50 N.m (37 lb ft) in sequence. Using J 45059 rotate each cylinder head bolt an additional 120 degrees.