Instrument Cluster / Carrier: Service and Repair

Instrument Cluster Replacement

Removal Procedure






Important: The ignition switch must be in the OFF position when removing the instrument cluster.

1. Remove the instrument panel (I/P) cluster trim plate.
2. Remove the instrument cluster screws.
3. Pull the instrument cluster towards you and disconnect the electrical connector.
4. Remove the instrument cluster.

Installation Procedure




1. Connect the electrical connector to the instrument cluster.
2. Align the instrument cluster to the I/P.

Notice: Refer to Fastener Notice.

3. Install the instrument cluster screws.

Tighten the instrument cluster screws to 2 N.m (18 lb in).

4. Install the I/P cluster trim plate.
5. If a new instrument cluster was installed, program the cluster. Refer to Instrument Cluster Programming and Setup. Programming and Relearning
6. Refer to Programming and RelearningProgramming and Relearning