Vehicle Speed Sensor: Service and Repair

Vehicle Speed Sensor Replacement

Removal Procedure




1. Raise and support the vehicle. refer to Vehicle Lifting.
2. Remove the right front tire and wheel.
3. Disconnect the vehicle speed sensor (VSS) electrical connector.
4. Remove wiring harness retainer from stud.




5. Remove the VSS stud (9).
6. Remove the VSS (10) from the extension case.




7. Remove the O-ring (11) from the VSS (10).

Installation Procedure




1. Install the O-ring (11) to the VSS (10).




2. Install the VSS (10).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the VSS stud (9).

Tighten the stud to 11 N.m (97 lb in).

4. Install the wiring harness retainer on stud.




5. Connect the VSS electrical connector.
6. Install the right front tire and wheel.
7. Lower the vehicle.