Turn Signal Switch Housing Replacement

Turn Signal Switch Housing Replacement

Removal Procedure





Caution: Refer to Restraint System in Service Precautions.

1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
2. Remove the turn signal cancel cam assembly. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement.
3. Remove the wiper washer switch assembly.
4. Remove the turn signal switch assembly. Refer to Turn Signal Multifunction Switch Replacement.
5. Slide the turn signal switch housing off of the steering column shaft assembly.

Installation Procedure





Important: The switch mounting bracket must be pressed firmly against the steering column tilt head.

1. Slide the turn signal switch housing onto the steering column shaft assembly.
2. Install the turn signal switch assembly.
3. Install the wiper washer switch assembly.
4. Install the turn signal cancel cam assembly.
5. Enable the SIR system.