71. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Tools Required

J 45059 Angle Meter





Notice: Ensure both components are aligned correctly or serious engine damage will occur.

1. Install the balancer onto the crankshaft indexing keyway. Use care to properly align the keyway and flats on the balancer with the oil pump drive.
2. Install the crankshaft balancer using a universal balancer installer.

Notice: Refer to Fastener Notice.

Important: Always install a NEW crankshaft balancer retaining bolt.

3. Install a NEW retaining bolt. Prevent the crankshaft from rotating when tightening the bolt.

Tighten the bolt to 100 N.m (74 lb ft) plus 125 degrees using the J 45059.