P0705
DTC P0705
Circuit Description
The park/neutral position (PNP) switch detects the gearshift position and signals these positions to the powertrain control module (PCM). The PNP switch detects the gear shift position so the engine can only be started in the PARK or NEUTRAL positions.
DTC P0705 will set if the PCM detects start-up in a drive range or vehicle speed in the PARK or NEUTRAL range. DTC P0705 is a type C DTC.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC P0705 Transmission Range (TR) Switch Circuit
Condition for Setting the DTC
The PCM detects 2 or more switches are ON at the same time for P, R, N, D, 2 and L positions.
Action Taken When the DTC Sets
* The PCM will use PNP switch to determine gear range.
* The PCM does illuminate the malfunction indicator lamp (MIL).
* The PCM records the operating conditions when the Conditions for Setting the DTC are met. The PCM stores this information as Failure Records.
* The PCM stores DTC P0705 in PCM history.
Conditions for Clearing the DTC
* A scan tool can clear the DTC.
* The PCM clears the DTC from PCM history if the vehicle completes 40 warm-up cycles without a non-emission related diagnostic fault occurring.
* The PCM cancels the DTC default actions when the fault no longer exists and the DTC passes.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
4. Disconnecting the transmission range switch, the ground path of all PNP switch circuits would be removed and the PCM would recognize all circuits as open. The scan tool will display HI for all range signals.
9. This step verifies the repair of the PNP switch wiring for an open or the lack of the signal voltage from the PCM.
