Instrument Panel Lower Trim Panel Replacement

Instrument Panel Lower Trim Panel Replacement

Removal Procedure

Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Disable the driver and passenger SIR system.
3. Remove the instrument panel (I/P) upper trim panel.
4. Remove the steering column.
5. Remove the body hinge pillar trim panels.
6. Remove the sill plates.
7. Remove the front floor console.
8. Remove glove compartment.
9. Remove the HVAC control assembly.
10. Remove manual selector.
11. Disengage the hood release cable from hood release handle.




12. Remove the following components from the lower instrument panel:

* The 8 bolts
* The 4 push retainers
* The wire harness clamps

13. Remove the lower instrument panel by pulling rearward.

Installation Procedure




1. Install the lower I/P assembly to the vehicle. Ensure that the 4 push retainers are fully engaged. Secure the assembly to the I/P reinforcement with the 8 bolts.
2. Route and install the I/P wiring harness clamps.
3. Connect the hood release cable to the hood release handle.
4. Install the manual selector.
5. Install the HVAC control assembly.
6. Install the glove compartment.
7. Install the front floor console assembly.
8. Install the hinge pillar trim panels.
9. Install the front sill plates.
10. Install the steering column.
11. Install the I/P upper trim panel.
12. Enable the driver and passenger side SIR system.
13. Connect the negative battery cable.