Center Pillar Upper Trim Panel Replacement

Center Pillar Upper Trim Panel Replacement

Removal Procedure




Caution: Refer to SIR Caution.

1. Disable the SIR System.
2. Remove the front side door sill trim plate.
3. Remove the rear door sill trim plate.
4. Remove the center pillar lower trim panel.
5. Remove the seat shoulder belt guide adjuster (1) trim cover and the bolt.
6. Position the belt (2) on the floor.




7. Remove the center pillar upper trim panel (2) by gently pulling loose.

Installation Procedure




1. Install the center pillar upper trim panel (2), by pushing in until tab (1) fastens.





Notice: Refer to Fastener Notice.

2. Install the seat shoulder belt guide adjuster (1) bolt.

Tighten the adjuster bolt to 42 N.m (31 lb ft).

3. Install the seat shoulder belt guide trim cover.
4. Install the center pillar lower trim panel.




5. Install the front side door sill trim plate (1) to the vehicle.
6. Install the rear side door sill trim plate.
7. Enable the SIR System.