Keyless Entry Module: Service and Repair

Remote Control Door Lock Receiver Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Remove the right upper quarter panel trim.




3. Disconnect the remote control door lock receiver electrical connector (2).
4. Remove the bolt (3) from the remote control door lock receiver (1).
5. Remove the remote control door lock receiver (1) from the vehicle.




6. Using a flat-bladed tool, remove the mounting bracket (1) from the receiver (2), if necessary.

Installation Procedure




1. Install the remote control door lock receiver (2) to the mounting bracket (1), if removed.




2. Install the remote control door lock receiver (1) to the vehicle.

Notice: Refer to Fastener Notice.

3. Install the bolt (3) to the door lock receiver (1).

Tighten the remote control door lock receiver bolt to 10 N.m (89 lb in).

4. Connect the remote control door lock receiver electrical connector (2).
5. Install the right upper quarter panel trim.
6. Connect the negative battery cable.
7. Reprogram the remote control door lock receiver, if necessary. Refer to Transmitter Programming. Programming and Relearning