Instrument Cluster Replacement

Instrument Cluster Replacement

Removal Procedure






Important: The ignition switch must be in the OFF position when removing the instrument cluster assembly.

1. Remove the IP cluster trim plate.
2. Remove the screw (1) which secures the instrument cluster assembly (2).
3. Disengage the 2 lower clips (3).
4. Disconnect the electrical connector from the cluster assembly (2).
5. Remove the cluster assembly (2) from the instrument panel assembly.

Installation Procedure




1. Connect the electrical connector to the instrument cluster assembly (2).
2. Install the cluster assembly (2) to the instrument panel assembly. Secure the assembly with the screw (1) and the 2 clips (3).
3. Install the IP cluster trim plate.