Backup Lamp Switch: Service and Repair

Backup Lamp Switch Replacement

Removal Procedure

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.




1. Disconnect the backup lamp connector.
2. Remove the backup light switch assembly.

Installation Procedure

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.





Notice: Refer to Fastener Notice.

1. Install the backup light switch with a new gasket.

Tighten the switch to 40 N.m (30 lb ft).




2. Connect the backup lamp connector.