Transmission Speed Sensor: Service and Repair

Vehicle Speed Sensor Replacement

Tools Required

J 36850 Transjel(R) Transmission Assembly Lubricant

Removal Procedure

Caution: Refer to Battery Disconnect Caution.

1. Disconnect the negative battery cable.




2. Disconnect the vehicle speed sensor (VSS) electrical connector (1).
3. Remove the one retaining bolt and the VSS from the transaxle.
4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.

Installation Procedure

1. Apply J 36850 to the VSS O-ring.

Notice: Refer to Fastener Notice.

2. Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS with the retaining bolt.

Tighten the VSS speed sensor (VSS) bolt to 6 N.m (53 lb in).




3. Connect the VSS electrical connector (1).
4. Connect the negative battery cable.