Battery Positive Fuse Block Cable Replacement

Battery Positive Fuse Block Cable Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution.

Important: Whenever battery cables are being replaced, always be certain to use a replacement cable that is the same type, size, and length. Some positive (+) cables have additional feed wires attached to them and some negative (-) cables have additional ground leads attached. Always be certain to route the replacement battery cable in exactly the same manner as the original cable.

1. Remove the battery from the vehicle.
2. Remove the plastic insulator from the positive (+) battery terminal.




3. Remove the nut (5) from the positive (+) battery cables.
4. Separate the positive (+) battery cable (4) from the battery positive fuse block feed cable.
5. Remove the battery positive fuse block feed cable from the harness retainers.
6. Remove the battery positive fuse block feed cable from the underhood fuse block.

Installation Procedure




1. Position the battery positive fuse block feed cable into the vehicle.
2. Install the battery positive fuse block feed cable to the underhood fuse block.

Notice: Refer to Fastener Notice.

3. Install the battery positive fuse block feed cable to positive (+) battery cable. Secure with the nut (5).

Tighten the positive (+) battery cable-to-relay block 1 feed cable retaining nut to 9 N.m (78 lb in).

4. Tape the loom to prevent dirt and moisture from entering the harness.
5. Install the positive (+) battery cable harness loom to the harness retainers.
6. Install the plastic insulator to the positive (+) battery cable.
7. Install the battery to the vehicle.