Stabilizer Bushing: Service and Repair

Stabilizer Shaft Insulator Replacement (FWD)

Removal Procedure

1. Remove the following components as an assembly.

* The front suspension crossmember
* The trans support
* The front control arms
* The stabilizer shaft
* The stabilizer shaft links
* The stabilizer shaft clamps
* The stabilizer shaft insulators




2. Remove the 4 bolts from the stabilizer shaft clamps.
3. Remove the 2 stabilizer shaft clamps.
4. Remove the 2 stabilizer shaft insulators.

Installation Procedure




1. Position the stabilizer shaft on the crossmember.
2. Install the 2 stabilizer shaft insulators to the stabilizer shaft.
3. Install the 2 clamps to the insulators.

Notice: Refer to Fastener Notice.

4. Install the 4 bolts to the clamps.

Tighten the bolts to 19 N.m (14.0 lb ft).

5. Install the stabilizer shaft and the crossmember to the vehicle.