Gearshift Selector Assembly Replacement

Gearshift Selector Assembly Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Remove the knob.
3. Remove the center instrument trim panel.
4. Remove the instrument compartment.
5. Remove the front floor console.




6. Remove the clip and washer, then disconnect the cable end from the shift lever assembly.




7. Turn the cable lock, then disconnect the shift cable from the shift lever assembly.




8. Remove the clip, then disconnect the cable end from the shift lever assembly.




9. Turn the lock, then disconnect the select cable from the shift lever assembly.
10. Remove the 4 nuts, then the shift lever assembly.

Installation Procedure

Notice: Refer to Fastener Notice.

1. Install the shift lever assembly, then the 4 nuts.

Tighten the nuts to 12 N.m (9 lb ft).

2. Install the shift cable into the shift lever assembly, then turn the lock clockwise to lock.




3. Connect the cable end of the shift cable to the shift lever assembly, then install the retaining clip.
4. Install the select cable into the shift lever assembly, then turn the lock clockwise to lock.
5. Connect the cable end of the select cable to the shift lever assembly, then install the retaining clip and washer.
6. Install the front floor console.
7. Install the instrument compartment.
8. Install the center instrument trim panel.
9. Install the knob.