Windshield Washer Reservoir: Service and Repair

WASHER SOLVENT CONTAINER REPLACEMENT

REMOVAL PROCEDURE




1. Remove the right side fender flare.
2. Remove the right side wheel house panel.
3. Disconnect the 2 washer pump electrical connectors (1).
4. Disconnect the washer pump hoses (4) from the washer pumps (3).
5. Remove the 3 bolts which secure the windshield washer solvent container (2).
6. Squeeze tabs on filler neck and pull down to remove washer solvent container (2) from vehicle.
7. Drain solvent from washer solvent container (2).
8. Remove the washer pumps (1) from the washer solvent container (2).

INSTALLATION PROCEDURE




1. Install the windshield washer pumps (1) to the windshield washer solvent container (2).
2. Install the windshield washer solvent container (2) by inserting the neck through the holes until tabs click.

3. NOTE: Refer to Fastener Note.

Install the 3 bolts to the windshield washer solvent container (2).

Tighten the washer solvent container bolts to 5.5 N.m (49 lb in).

4. Connect the washer hoses (4) to the washer pumps (3).
5. Connect the washer pump electrical connectors (1).
6. Install the right wheel house panel.
7. Install the right fender flare.
8. Fill the washer solvent container (2) with washer solvent.