Front Floor Console Trim Plate Replacement

Front Floor Console Trim Plate Replacement

Removal Procedure





1. Remove the floor console. Refer to Front Floor Console Replacement (Removal and Replacement) .
2. Remove the ashtray insert.
3. Remove the cupholder liner.
4. Remove the wiring harness.
5. Remove the HUD switch, if equipped. Refer to Head Up Display Switch Replacement (Head Up Display Switch Replacement) .
6. Remove the traction control switch. Refer to Electronic Traction Control Switch Replacement (Service and Repair) .
7. Remove the accessory power receptacles. Refer to Cigarette Lighter Housing Replacement - Floor Console (Service and Repair) and to Floor Console Accessory Power Receptacle Replacement (Service and Repair) .
8. Remove the armrest and the hinge. Refer to Front Floor Console Armrest Replacement (Removal and Replacement) .
9. Remove the rear cover screws.




10. Remove the rear cover.




11. Remove the compartment screws.




12. Remove the side trim panel screws.
13. Remove the side trim panels.




14. Remove the compartment screws.




15. Remove the upper trim plate.



Installation Procedure





1. Align the compartment to the upper trim plate.





Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the compartment screws.

Tighten the screws to 2 N.m (18 lb in).





3. Align the side trim panels to the locators.
4. Install the side trim panel screws.

Tighten the screws to 2 N.m (18 lb in).





5. Install the compartment screws.

Tighten the screws to 2 N.m (18 lb in).





6. Align the rear cover to the floor console.




7. Install the rear cover screws.

Tighten the screws to 2 N.m (18 lb in).

8. Install the armrest and the hinge. Refer to Front Floor Console Armrest Replacement (Removal and Replacement) .
9. Install the accessory power receptacles. Refer to Cigarette Lighter Housing Replacement - Floor Console (Service and Repair) and to Floor Console Accessory Power Receptacle Replacement (Service and Repair) .
10. Install the traction control switch. Refer to Electronic Traction Control Switch Replacement (Service and Repair) .
11. Install the HUD switch, if equipped. Refer to Head Up Display Switch Replacement (Head Up Display Switch Replacement) .
12. Install the wiring harness.
13. Install the cupholder liner.
14. Install the ashtray insert.
15. Install the floor console. Refer to Front Floor Console Replacement (Removal and Replacement) .