Operation CHARM: Car repair manuals for everyone.

Accessory Wiring Junction Block Replacement



Accessory Wiring Junction Block Replacement

Removal Procedure





1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26 - 3.8L) (Service and Repair)Battery Negative Cable Disconnection and Connection (LS4 - 5.3L) (Service and Repair) .
2. Remove the instrument panel (I/P) compartment access hole cover.




3. Disconnect the body wiring harness from the accessory wiring junction block. Pull the harness away from the block for access.
4. Open the I/P compartment. Access the junction block bolt through the open I/P compartment. Remove the junction block bolt.




5. Disengage the junction block tabs from the passenger knee bolster. Pull the junction block away from the I/P.
6. Remove the junction block.



Installation Procedure





1. Seat the bottom junction block tabs and snap the top of the junction block to the passenger knee bolster.





Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the junction block bolt.

Tighten the junction block bolt to 10 N.m (89 lb in).

3. Close the I/P compartment.
4. Connect the body wiring harnesses to the junction block.

Tighten the connector bolt to 2.5 N.m (22 lb in).





5. Install the I/P compartment access hole cover.
6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26 - 3.8L) (Service and Repair)Battery Negative Cable Disconnection and Connection (LS4 - 5.3L) (Service and Repair) .