Instrument Cluster Head Up Display Replacement

Instrument Cluster Head Up Display Replacement

Removal Procedure

1. Pull the I/P accessory trim plate rearward slightly for access to the steering column filler. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair) .
2. Remove the I/P steering column opening filler. Refer to Steering Column Opening Filler Replacement (Service and Repair) .
3. Remove the I/P cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement (Service and Repair) .
4. Remove the instrument cluster. Refer to Instrument Cluster Replacement (Instrument Cluster Replacement) .
5. Remove the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement (Service and Repair) .





Notice: Use the following method to disengage the Head Up Display (HUD) retainers. Do NOT pry the retainers with a flat-bladed tool or other similar device.

1. Disengage the I/P upper trim panel retainers on the sides of the HUD.
2. Disengage the retainer rearward of the HUD.

Failure to follow this method could break the tab on the HUD.

6. Remove the I/P upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement (Service and Repair) .
7. Remove the HUD screw.




8. Remove the HUD bolts.




9. Adjust the HUD for access. Disconnect the HUD electrical connector.
10. Remove the HUD



Installation Procedure





1. Connect the HUD electrical connector. Lower the HUD into the I/P opening.





Notice: Refer to Fastener Notice (Fastener Notice) .

2. Start the HUD bolts by hand to avoid cross threading. Install the HUD bolts.

Tighten the bolts to 10 N.m (89 lb in).





3. Install the HUD screw.

Tighten the screw to 2 N.m (18 lb in).

4. If a new HUD was installed remove the protective plastic sheet from the glass.
5. Install the I/P upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement (Service and Repair) .
6. Install the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement (Service and Repair) .
7. Install the instrument cluster. Refer to Instrument Cluster Replacement (Instrument Cluster Replacement) .
8. Install the I/P cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement (Service and Repair) .
9. Install the I/P steering column opening filler. Refer to Steering Column Opening Filler Replacement (Service and Repair) .
10. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair) .