Park/Turn Signal Lamp Bulb Replacement (GT)

Park/Turn Signal Lamp Bulb Replacement (GT)

Removal Procedure

The front park/turn lamp bulb shares the same housing as the fog lamp.





1. Remove the front fog lamp screws (1) from the fog lamp.




2. Remove the fog lamp from the front bumper fascia.
3. Remove the park/turn lamp bulb/socket from the fog lamp, turning counterclockwise, if required.




4. Disconnect the electrical connector from the park/turn lamp bulb/socket.



Installation Procedure





1. Connect the electrical connector to the park/turn lamp bulb/socket.




2. Install the park/turn lamp bulb/socket to the fog lamp, turning clockwise, if required.
3. Position the fog lamp to the front bumper fascia.





Notice: Refer to Fastener Notice .

4. Install the front fog lamp screws (1) to the fog lamp.

Tighten the screws to 2 N.m (18 lb in).

5. Inspect and adjust the front fog lamp aim as necessary. Refer to Fog Lamp Aiming (GT) (Fog Lamp Aiming (GT))Fog Lamp Aiming (GXP) (Fog Lamp Aiming (GXP)) .