Limited Slip Differential Assemble

Limited Slip Differential Assemble

Special Tools

J 42162 - Getrag Axle Side Gear Compressor




1. Install a beveled washer (108) on the axle side gear with bevel facing out.




2. Install a thick pressure plate (109) with friction material facing away from the gear teeth.





Note: Friction discs and separator plates develop specific wear patterns. During disc and plate installation, keep the components in the order in which they were removed.

3. Install the steel plate against friction material of the pressure plate. Alternate the installation of steel plates and friction discs. Ensure that the last steel plate of the clutch pack (110) is against the case half.
4. Repeat steps 1 through 3 for the other side.




5. Install the assembled axle side gear (107) into the right case half (105).
6. Align tabs on the steel plates to fit the grooves.




7. Install the assembled axle side gear (107) into the left case half (104).
8. Align tabs on the steel plates to fit the grooves.





Note: When using the hydraulic press, apply light pressure on the pinion gears and washers so they align with the pinion differential shaft bores.

9. Using the J 42162 - compressor and a press, install the pinion gears and washers.
10. Install the differential shaft (103) ensuring that it moves through the washers and gears properly.




11. Align bolt holes between the halves and lightly press them together.




12. Install the ring gear (2) into the differential carrier (3).
13. Install 10 NEW ring gear bolts (1) in order to align the gear to the hub. Hand tighten at this time.

Caution: Refer to Fastener Caution (Fastener Caution).

14. Tighten the ring gear bolts to 185 Nm (136 lb ft)