P150C

DTC P150C (2.4L)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC P150C
- Transmission Control Module (TCM) Engine Speed Request Circuit

Circuit/System Description

The transmission control module (TCM) and the engine control module (ECM) monitor the number of Engine Speed Request Circuit serial data messages transmitted/received between modules.

Conditions for Running the DTC

The engine is running.

Conditions for Setting the DTC

The ECM detects greater than 2 message count errors.

Action Taken When the DTC Sets

* DTC P150C is a type B DTC.
* The ECM Disables engine speed requests from transmission.

Conditions for Clearing the DTC

DTC P150C is a type B DTC.

Diagnostic Aids

A problem on the serial data circuit will not cause this DTC.

Reference Information
Description and Operation

Data Link Communications Description and Operation (Description and Operation)
DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

If the DTC resets, replace the TCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for TCM replacement, setup, and programming.