Prop Flange Assemble

Prop Flange Assemble

Special Tools

J 8614-01 - Flange and Pulley Holding Tool

For equivalent regional tools, refer to Special Tools (Tools and Equipment).




1. Install the NEW output shaft assembly retainer (30).
2. Install the NEW prop shaft flange o-ring seal (32) into the prop shaft flange (31) - model dependent.
3. Install the prop shaft flange (31).
4. Put the transmission in Park.

Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the NEW prop shaft flange thrust washer (33) and NEW prop shaft flange nut (34) using GM P/N 89021297. Tighten the prop shaft flange nut (34) to 57 Nm (42 lb ft).
6. Using either the J 8614-01 - holding tool to tighten the prop flange nut.