P0752

DTC P0752

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC P0752 Shift Solenoid (SS1) Valve Performance or Stuck On

Conditions for Setting the DTC

* The shift solenoid (SS) 1 is stuck ON.
* The drive (D) range is selected.
* The engine coolant is 60° C (140°F) or greater.
* Twenty seconds have passed since the transaxle was placed in Drive (D).
* The engine revolution is 600 RPM or greater.
* No failure of output speed sensor, input speed sensor, engine revolution, water temperature signal, solenoid electrical, ranger sensor, throttle signal.

Action Taken When the DTC Sets

The transmission control module (TCM) will request the illumination of the Hold/Malfunction Indicator Lamp (MIL) and store the DTC when the TCM detects failures on 2 consecutive ignition cycles.

Conditions for Clearing the DTC

* The TCM turns off the Hold/Malfunction Indicator Lamp (MIL) when no further failures are detected on the next ignition cycle.
* The scan tool can clear the DTC from the TCM history.
* The TCM clears the DTC from the TCM history memory after 40 consecutive ignition cycles without fault.

Cause of Failure

* Shift solenoid 1 (SS1)
* The inside valve body
* The TCM