Stabilizer Bar: Service and Repair

Stabilizer Shaft Replacement

Removal Procedure




1. Remove the crossmember assembly. Refer to Front Suspension Crossmember Replacement (Service and Repair).
2. Remove the stabilizer bar from the crossmember assembly by removing the U-clamp bolts.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the U-clamps and the stabilizer bar to the crossmember and tighten to 25 Nm (18 lb ft).
2. Install the crossmember assembly. Refer to Front Suspension Crossmember Replacement (Service and Repair).