37. Torque Converter Seal Removal

Torque Converter Seal Removal

Special Tools
* J 41103-1 - Torque Converter Seal Puller Legs
* J 41103-2 - Torque Converter Seal Puller Bridge
* J 41103-3 - Torque Converter Seal Support Body

For equivalent regional tools, refer to Special Tools (Tools and Equipment).




1. Insert the three J 41103-1 - puller legs under the Torque Converter Seal (54).
2. Insert the J 41103-3 - support body over the stator shaft (43).
3. Insert the J 41103-2 - puller bridge over the J 41103-3 - support body. Connect the J 41103-1 - puller legs into the slots on the J 41103-2 - puller bridge.

Note: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.

4. Tighten the forcing screw on the J 41103-2 - puller bridge until the J 41103-1 - puller legs remove the torque converter seal (54).