B3669

DTC B3669

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors
DTC B3669 01
- Deck Lid Position Sensor Circuit short to battery

DTC B3669 06
- Deck Lid Position Sensor Circuit short to ground or open

DTC B3669 58
- Deck Lid Position Sensor Circuit incorrect reaction after event

DTC B3669 59
- Deck Lid Position Sensor Circuit circuit/component protection time out

Diagnostic Fault Information






Circuit/System Description

S2 is the Rear Compartment Cylinder Extended Sensor. The folding top control (FTC) module uses S2 to determine the position of the deck lid while in the reverse open position. S2 is a hall effect sensor that becomes active when the deck lid is in the reverse open position.

Conditions for Running the DTC

The FTC module is active.

Conditions for Setting the DTC

A short to ground, short to voltage, or open is detected on the signal circuit of S2.

Action Taken When the DTC Sets

The top is disabled.

Conditions for Clearing the DTC

The fault is no longer present and the top completes one cycle.

Diagnostic Aids

A weak battery may cause DTC B3669 58 or DTC B3669 59 to set.

Reference Information
Schematic Reference

Folding Top Schematics [1][2]Convertible Top
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation

Power Folding Top Description and Operation Power Folding Top
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearning for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at S2.
2. Ignition ON, verify a test lamp illuminates between the 12-volt reference circuit terminal 2 and ground.

• If the test lamp does not illuminate, test the 12-volt reference circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the FTC module.

3. Verify a test lamp illuminates between the signal circuit terminal 1 and B+.

• If the test lamp does not illuminate, test the signal circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the FTC module.

4. Test the signal circuit for a short to voltage. If the circuit test is normal, replace S2.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement - Rear Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement - Rear
* Folding Top Control Module Replacement Service and Repair