C0558

DTC C0558

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor
DTC C0558
- Calibration Data Not Programmed/Learned

Circuit/System Description

The electronic brake control module (EBCM) must be programmed.

Conditions for Running the DTC

Ignition voltage is greater than 9.6 volts.

Conditions for Setting the DTC

The EBCM has not been programmed.

Actions Taken When DTC Sets

* The EBCM disables the ABS and the TCS for the duration of the ignition cycle.
* The ABS indicator turns ON.
* The TC indicator turns ON.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation

ABS Description and Operation Description and Operation
Electrical Information Reference

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearning for scan tool information.

Circuit/System Verification

Verify that DTC C0558 is not set.

If the DTC is set, program the EBCM. If the DTC resets, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Programming and Relearning for EBCM calibration