Trunk / Liftgate Latch: Service and Repair

Rear Compartment Lid Latch Replacement

Removal Procedure

1. Open the rear compartment.




2. Release the lock rod from the lock cylinder.
3. Remove the latch bolts from the rear compartment lid.
4. Reposition the latch to gain access to the wiring harness connector.
5. Disconnect the wiring harness connector from the latch.
6. Remove the latch assembly from the rear compartment lid.

Installation Procedure




1. Position the latch assembly into the rear compartment lid.
2. Connect the latch wiring harness connector.

Caution: Refer to Fastener Caution Fastener Caution.

3. Install the latch assembly bolts.

Tighten the bolts to 10 Nm (89 lb in).

4. Install the lock rod to the lock clip.
5. Close the rear compartment.