Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Balancer Replacement

Special Tools
* J 38122-A Harmonic Balancer Holder
* J 45059 Angle Meter

Removal Procedure




1. Remove the engine drive belt. Refer to Drive Belt Replacement Service and Repair.
2. Use the J 38122-A in order to prevent the crankshaft from rotating while loosening the crankshaft balancer bolt.




3. Remove and discard the crankshaft balancer bolt.




4. Remove the crankshaft balancer.

Installation Procedure




1. Position the crankshaft balancer to the engine.




2. Install a NEW crankshaft balancer bolt.





Caution: Refer to Fastener Caution Fastener Caution.

3. Use the J 38122-A in order to prevent the crankshaft from rotating while tightening the crankshaft balancer bolt.

Tighten the bolt to 100 Nm (74 lb ft) plus an additional 125 degrees using the J 45059 .

4. Install the engine drive belt. Refer to Drive Belt Replacement Service and Repair.