49. Cylinder Head Installation

Cylinder Head Installation

Special Tools

J 45059 - Angle Meter

For equivalent regional tools, refer to Special Tools Special Tools.





Note: Do not use any sealing material.

1. Install the cylinder head gasket (2) to the block.
2. Install the cylinder head (1).





Caution: Refer to Fastener Caution Fastener Caution.

Note: Always use new cylinder head bolts.

3. Install and tighten the cylinder head bolts in sequence.

* Tighten the bolts to 30 Nm (22 lb ft).
* Using the J 45059 - meter, tighten the bolts an additional 155 degrees in sequence.




4. Install the front cylinder head bolts (1) and tighten to 35 Nm (26 lb ft).