Fuel Pressure Gauge Installation and Removal

Fuel Pressure Gauge Installation and Removal

Special Tools

CH-48027 Digital Pressure Gauge

Installation Procedure
Warning: Refer to Gasoline/Gasoline Vapors Warning Service Precautions.

Warning: Refer to Relieving Fuel Pressure Warning Service Precautions.





1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027) Fuel Pressure Relief (With CH 48027)Fuel Pressure Relief (Without CH 48027) Fuel Pressure Relief (Without CH 48027).
2. Connect the CH-48027-1 (1) to the CH-48027-2 (2).
3. Remove the shop towel from around the fuel rail service port, and place in an approved gasoline container.
4. Perform any tests and/or diagnostics as needed. For the proper usage of the CH-48027, refer to the manufacture's directions.

Removal Procedure




1. Relieve the fuel system pressure, if required. Perform the following steps:

Warning

Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will absorb any fuel leakage that occurs during the connection of the fuel pressure gauge. Place the towel in an approved container when the connection of the fuel pressure gauge is complete.

1. Wrap a shop towel around the fuel rail service port.
2. Place the hose on the CH-48027-2 (2) into an approved gasoline container.
3. Open the valve on the CH-48027-2 (2) in order to bleed any fuel from the fuel rail.
4. Close the valve on the CH-48027-2 (2).
5. Remove the hose on the CH-48027-2 (2) from the approved gasoline container.
6. Remove the shop towel from around the fuel rail service port, and place in an approved gasoline container.

Caution: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:

* The fuel pipe connections
* The hose connections
* The areas surrounding the connections

2. Disconnect the CH-48027-1 (1) from the CH-48027-2 (2).
3. Disconnect the CH-48027-2 (2) from the CH-48027-3 (4).
4. Disconnect the CH-48027-3 (4) from the fuel rail service port.
5. Install the fuel rail service port cap.
6. install the engine cover, if required.
7. Tighten the fuel fill cap.