Rear Suspension

Rear Wheel Bearing and Hub Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement Rear Brake Rotor Replacement.




4. Disconnect the electrical connector from the wheel speed sensor, if equipped with ABS.
5. Remove the stabilizer link bolt at the knuckle and position the stabilizer link out of the way in order to provide access to the wheel bearing/hub nuts. Refer to Stabilizer Shaft Replacement Rear Suspension.
6. Remove the 4 wheel bearing/hub assembly nuts.
7. Remove the wheel bearing/hub assembly from the knuckle.

Installation Procedure




1. Install the wheel bearing/hub assembly to the knuckle.

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the 4 wheel bearing/hub assembly nuts.

Tighten the nuts to 63 Nm (47 lb ft).

3. Connect the stabilizer link bolt at the knuckle. Refer to Stabilizer Shaft Replacement Rear Suspension.
4. Connect the electrical connector to the wheel speed sensor, if equipped with ABS.
5. Install the brake rotor. Refer to Rear Brake Rotor Replacement Rear Brake Rotor Replacement.
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
7. Lower the vehicle.