Transmission Rear Mount Replacement

Transmission Rear Mount Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the left tire and wheel. Refer to Tire and Wheel Removal and Installation Service and Repair.
3. Using a suitable jack stand, support the rear of the powertrain.




4. Remove the transmission mount to bracket through bolt (1).




5. Remove the transaxle brace bolts (1), then loosen bolt (3) until it no longer engages the transaxle.
6. Remove the transaxle brace (2) with bolt (3) still retained in the brace.




7. Remove the transmission mount to transmission bolts (2).
8. Unclip the wiring harness retainer, then remove the transmission mount (1).

Installation Procedure




1. Install the transmission mount (1).

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the transmission mount to transmission bolts (2) and tighten to 90 Nm (66 lb ft).




3. Install the transaxle brace (2) with bolt (3) seated in the brace.
4. Install the transaxle brace bolt (1) and tighten to 50 Nm (37 lb ft).
5. Tighten brace bolt (3) to 100 Nm (74 lb ft).




6. Install the transmission mount to bracket through bolt (1) and tighten to 90 Nm (66 lb ft).
7. Remove the jack stand.
8. Install the left tire and wheel. Refer to Tire and Wheel Removal and Installation Service and Repair.
9. Lower the vehicle.