4T65-E - Automatic Transmission

Input Speed Sensor Replacement

Removal Procedure




1. Remove the case side cover. Refer to Control Valve Body Cover Replacement Control Valve Body Cover Replacement.
2. Disconnect the input speed sensor electrical connector.
3. Remove the input speed sensor retaining clip (441).
4. Remove the input speed sensor (440).




5. Inspect the input speed sensor (440) for the following conditions:

* Damaged or missing magnet
* Damaged housing
* Bent or missing electrical terminals
* Damaged speed sensor clip (441)

Installation Procedure




1. Install the input speed sensor (440).
2. Install the input speed sensor retaining clip (441).
3. Connect the input speed sensor electrical connector.
4. Install the case side cover. Refer to Control Valve Body Cover Replacement Control Valve Body Cover Replacement.