Blower Motor Control Processor Replacement

Blower Motor Control Processor Replacement

Removal Procedure

1. Remove the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side Instrument Panel Insulator Panel Replacement - Right Side.
2. Remove the blower motor control processor wire harness connector.
3. Remove the blower motor control processor screws.




4. Remove the blower motor control processor.

Installation Procedure




1. Install the blower motor control processor.

Caution: Refer to Fastener Caution Fastener Caution.

2. Tighten the blower motor control processor screws.

Tighten the screws to 1.5 Nm (13 lb in).

3. Install the blower motor control processor wire harness connector.
4. Install the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side Instrument Panel Insulator Panel Replacement - Right Side.