Knock Sensor Replacement - Bank 2

Knock Sensor Replacement - Bank 2

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Disconnect the engine wiring harness electrical connector (2) from the knock sensor.




3. Remove the knock sensor bolt and sensor.

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

1. Position the knock sensor to the engine block and install the knock sensor bolt.

Tighten the bolt to 25 Nm (18 lb ft).




2. Connect the engine wiring harness electrical connector (2) to the knock sensor.
3. Lower the vehicle.