Remote Control Door Lock Receiver Antenna Replacement

Remote Control Door Lock Receiver Antenna Replacement

Removal Procedure

Warning: Refer to Battery Disconnect Warning (Service Precautions).

1. Disconnect the negative battery cable.
2. Remove the right upper quarter panel trim. Refer to Quarter Upper Trim Panel Replacement (Quarter Upper Trim Panel Replacement).




3. Disconnect the remote control door lock receiver electrical connector (2).
4. Remove the bolt (3) from the remote control door lock receiver (1).
5. Remove the remote control door lock receiver (1) from the vehicle.




6. Using a flat-bladed tool, remove the mounting bracket (1) from the receiver (2), if necessary.

Installation Procedure




1. Install the remote control door lock receiver (2) to the mounting bracket (1), if removed.




2. Install the remote control door lock receiver (1) to the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the bolt (3) to the door lock receiver (1).

Tighten the remote control door lock receiver bolt to 10 Nm (89 lb in).

4. Connect the remote control door lock receiver electrical connector (2).
5. Install the right upper quarter panel trim. Refer to Quarter Upper Trim Panel Replacement (Quarter Upper Trim Panel Replacement).
6. Connect the negative battery cable.
7. Reprogram the remote control door lock receiver, if necessary. Refer to Remote Control Door Lock Transmitter Programming (Testing and Inspection).