39. 2nd Clutch Housing Assemble

2nd Clutch Housing Assemble

Special Tools

J 41107 Axle Seal Installer Kit




1. Coat the discs with ATF WS.
2. Install the plates (2) and discs (1).




3. Coat the 2nd clutch piston with ATF WS, and install it to the 2nd clutch housing assembly.




4. Install the 2nd clutch piston return spring (1) sub-assembly using J 41107 and 4 equal length blocks
5. Using a press, compress the piston return spring.

Note: Stop pressing when the spring seat is 1-2 mm (0.039-0.078 in) from the snap ring groove. This prevents the spring seat from being deformed.

6. Using a screwdriver, install the snap ring.




7. Install the 2nd clutch piston assembly (1) to the transaxle case.





Note: After installing the snap ring, confirm that there is no clearance between the 2nd clutch cylinder and the contact surface of the cylinder in the transaxle case.

8. Install the snap ring and measure the inside diameter.

Inside diameter - more than 167 mm (6.57 in)