48. Output Carrier Assembly Installation

Output Carrier Assembly Installation





Note: Firmly engage all the discs of the 5th gear clutch with the hub splines of the output carrier assembly and securely assemble them.

1. Install the output carrier assembly (1) to the transmission case.





Note: Write down dimension E because it is necessary for the following process.

2. Using a straightedge and vernier calipers, measure the gap between the top of the differential drive pinion in the output carrier assembly and contact surface of the transaxle case and housing (Dimension E).





Note: Write down dimension F because it is necessary for the following process.

3. Measure two places on the transmission housing, and calculate dimension F using the following formula - Dimension F = Dimension (1) - Dimension (2).




4. Install the thrust bearing race (1) to the output gear while checking its direction.

* Bearing Inside Race Diameter - 34.5 mm (1.359 in)
* Bearing Outside Race Diameter - 48.5 mm (1.909 in)