46. Oil Pan Installation (Upper)
Oil Pan Installation (Upper)
Note:
* Remove any oil from the contact surface.
* Install the crankcase within 3 minutes after applying seal packing.
* Do not start the engine for at least 2 hours after installing the stiffening crankcase.
1. Apply Three Bond 1207B or equivalent, in a continuous bead (diameter: 2.5 mm (0.098 in)) to the places shown (1, 2, 3).
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the stiffening crankcase with the 11 bolts (4-14) and tighten to 21 Nm (16 lb ft).
3. Check the torque for bolts 1 and 2 and tighten to 21 Nm(16 lb ft).
4. Wipe off any excess seal packing with a clean piece of cloth.