48. Intake Manifold Installation
Intake Manifold Installation
Caution: Refer to Fastener Caution (Fastener Caution).
1. Install the radio setting condenser with the bolt (1) and tighten to 10 Nm (7 lb ft).
2. Install the thermostat.
3. Install the inlet water.
4. Install the inlet water hose with the 2 clamps (1, 2).
5. Install the water by-pass hose with the clamp.
6. Install the water by-pass pipe with the 2 bolts (1, 2) and tighten to 21 Nm (16 lb ft).
7. Connect the water by-pass hose (1) to the inlet water housing.
8. Install the ventilation hose.
9. Install the 4 ignition coils with the 4 bolts and tighten to 10 Nm (7 lb ft).
10. Install the fuel injector assembly.
11. Install the delivery pipe spacer.
12. Install the fuel delivery pipe assembly.
13. Connect the fuel tube assembly.
14. Install a new gasket to the intake manifold.
15. Install the intake manifold and intake manifold stay with the 4 bolts (1, 3, 5, 6)and 2 nuts (2, 4) and tighten to28 Nm (21 lb ft).
16. Connect the 2 water by-pass hoses (1, 2).
17. Connect the ventilation hose to the intake manifold.
18. Install the air tube with the 2 bolts and tighten to 10 Nm (7 lb ft).
19. Install the wire harness bracket and tighten to 10 Nm (7 lb ft).
20. Install the bolt and fan belt adjusting bar and tighten to 19 Nm (14 lb ft).
21. Install the engine hanger.
22. Remove the engine stand.
23. Attach the engine to the sling device with the chain block.
24. Remove the engine from the engine stand.