55. Control Valve Body Installation

Control Valve Body Installation





Caution: Refer to Fastener Caution (Fastener Caution).

Note:
* Push the valve body against the accumulator piston spring and the actuator valve to install it.
* Hand tighten the bolts marked by (1) first because they are positioning bolts.

1. Check the manual valve lever position. Install the valve body to the transaxle case with the bolts (1-3) and tighten to 11 Nm (97 lb in). Refer to Transmission General Specifications (Transmission General Specifications) for Bolt Length - E.




2. Coat a new O-ring (1) with ATF WS, and install it to the transmission wire and install the harness to the transmission.




3. Install the transmission wire retaining bolt and tighten to 5 Nm (44 lb in).
4. Coat the ATF temperature sensor O-ring with ATF WS.
5. Install the ATF temperature sensor with the lock plate and bolt and tighten to 7 Nm (62 lb in).
6. Connect the solenoid connectors.